方法
工作台呈现已接受的计算响应，并保留声明的平均和峰值运行工况。
用于初步固液分离筛查，覆盖沉降速度、重力与总通量、状态点行为、密实极限通量、澄清/浓缩状态及诊断。
FluxMatrix Studio
Steady-state secondary clarifier solids-flux and state-point analysis for activated sludge systems.
01 · Geometry
Clarifier geometry
For rectangular geometry, blank uses 2 × (L + W). For circular geometry, blank uses π × D.
02 · Operating loads
Hydraulic and solids loading
The selected settling correlation uses SVI in mL/g.
03 · Settling model
Vesilind correlation
The default SVI correlation is a screening approximation; site-specific settling test data are more reliable.
Output · Operating status
Results overview
Selected case status Safe / underloaded Waiting for calculation.
Average case Safe / underloaded
Peak case Unstable / overloaded
Limiting flux GL — kg/(m²·h)
Surface overflow rate — m/h
Solids loading SLR — kg/(m²·h)
Theoretical RAS concentration — mg/L
Smallest selected-case margin — Minimum of clarification / thickening margin
Primary visualization · SPA
State-point / flux plot
Hover or focus a plotted marker for a numeric readout.
The active case is shown with solid curves and markers. The inactive case remains as a reference marker so average versus peak behavior can be compared without changing the input basis.
Condition view · Illustrative
Clarifier condition visualizer
Illustrative condition view based on current solids-loading and flux margins. Not a CFD model or a field blanket measurement replacement.
The blanket fill is a deterministic visual mapping from Ga / GL only. V1 does not report a numeric sludge blanket depth.
Sensitivity scan · RAS
RAS operating window
Deterministic scan for the selected operating case. Every point recomputes underflow velocity, total-flux limiting capacity, demand, margins, and status.
| Qr / Q | Qr (m³/h) | Load ratio | Minimum margin | Status |
|---|
Review · Deterministic diagnostics
Diagnostics and recommendations
Warnings
- No warnings yet.
Recommendations
- No recommendations yet.
Traceability · Calculation record
Verification
A concise record of the current validated calculation basis.
Calculation statusPending
Selected caseAverage
Model / correlationDaigger-Roper (1985)
Verification availabilityAwaiting current result
Calculate the current input set to populate the engineering trace.
Inputs changed. Recalculating the current steady-state screening basis...
ATLAS WTS · Process engineering FluxMatrix report Validated screening record
此工程工具目前仅提供英文版本。
01
工程依据
标准 / 参考依据
假设
- 初步工艺评估使用已声明的池体几何尺寸和运行负荷。
- 单位和工程标识保持其规范含义。
范围 / 限制
- 最终设计应根据项目数据、适用标准和注册工程师审查确认。